Projects / Water litre counter / Fault finder

Fault finder: Water litre counter

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No pulses: what should I check?

Check the yellow wire is on D2 and the sensor arrow follows the flow.

Total runs backwards or jumps: what should I check?

Check the wiring and the pull-up resistor.

Total too high or low: what should I check?

Adjust PULSES_PER_LITRE with the jug test.

Display blank: what should I check?

Check A4 and A5.

Water near the electronics: what should I check?

Switch off and dry everything before use.