Fault finder: XBee point-to-point link

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No data: what should I check?

Network ID or baud rate mismatch; check both in XCTU.

Garbage characters: what should I check?

Baud rates differ.

Module resets while sending: what should I check?

Power supply cannot give 250 mA.

Module hot or dead: what should I check?

5 V was connected; fit the divider and the 3.3 V supply.

Short range: what should I check?

Antenna orientation and obstacles.