Fault finder: Egg timer ring
8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Ring shows random colours: what should I check?
Check the data pin and add the 330 ohm resistor.
First LED wrong colour: what should I check?
Try NEO_RGB or NEO_GRB to match your ring.
Board resets: what should I check?
Lower the brightness or power the ring from a separate 5 V supply.
Timer short or long: what should I check?
Change MINUTES to suit your eggs and kitchen.
Buzzer quiet: what should I check?
Use a passive buzzer with tone().
