Fault finder: Addressable LED strip with light modes

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

You wired the DOUT end. Move the data wire to DIN, the end the arrows start from.

Colours wrong (red shows green): what should I check?

Change GRB to RGB in addLeds.

Flicker or random colours: what should I check?

Shared ground missing, or the data wire is long. Keep it short and use the 330 Ω.

Far end goes yellow or dim: what should I check?

Feed 5 V into both ends of the strip.