Fault finder: Workstation cycle timer

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No pass seen: what should I check?

Turn the magnet over, the A3144 reacts to one pole.

Too many counts: what should I check?

Raise MIN_CYCLE_MS or keep the magnet further away.

Display blank: what should I check?

Check the OLED address 0x3C and the I2C wires.

Odd times: what should I check?

Make sure the sensor output has its 10 kilohm pull-up.

Sensor too sensitive: what should I check?

Increase the gap between magnet and sensor.