Fault finder: Wire heating test
5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Readings low: what should I check?
Shiny copper has low emissivity; compare with a stuck-on thermometer.
No rise: what should I check?
Check the supply is in current mode.
Sensor not found: what should I check?
Check the I2C wiring.
Wire smells: what should I check?
Stop and ventilate.
