Fault finder: Wind vane with a magnetic angle sensor

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings jump: what should I check?

Check the magnet is centred and the gap is 1 to 2 mm.

Reads a fixed value: what should I check?

Check I2C wiring and the sensor's address 0x36.

Direction is mirrored: what should I check?

Turn the magnet over or change the sign of the angle.

Vane sticks: what should I check?

Use better bearings and balance the vane.