Fault finder: Wi-Fi robot car with a phone joystick

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Page does not load: what should I check?

Check you are on the RobotCar network and use http, not https.

Page loads, car does not move: what should I check?

Check the WebSockets library and the TB6612 STBY pin on 3V3.

One wheel backwards: what should I check?

Swap its two motor wires.

ESP32 resets when motors start: what should I check?

Check the buck module, add a 470 uF capacitor on the 5 V line.

Car keeps creeping: what should I check?

Increase the dead zone in setMotor.