Projects / Whack-a-LED game / Fault finder

Fault finder: Whack-a-LED game

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display shows nothing: what should I check?

Check CLK and DIO are not swapped and that you installed the right library.

Same LED comes up every time: what should I check?

A0 must be left floating, not tied to ground.

Game ends right away: what should I check?

A button is stuck or wired to GND all the time.

Two LEDs seem to light: what should I check?

Check the D2 to D5 wiring for a shared resistor.

Best score does not save: what should I check?

Use EEPROM.update as shown, not a loop that never finishes.