Fault finder: One-press Wi-Fi button

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never wakes: what should I check?

The wake pin must be an RTC-capable pin on the C3: GPIO 0 to 5. Check it is GPIO 3.

Wakes by itself: what should I check?

The pin is floating. Add a 100 kΩ pull-up resistor.

Fails to connect: what should I check?

Weak Wi-Fi. Move closer or increase the timeout.

Battery drains quickly: what should I check?

Board LED and regulator draw current. Use a low-quiescent regulator.