Fault finder: Drinking water TDS and pH meter
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
pH reading drifts: what should I check?
Recalibrate and keep the probe wet.
TDS jumps: what should I check?
Keep the probe away from the sides of the glass and stir gently.
Temperature reads -127: what should I check?
Check the DS18B20 wiring and pull-up resistor.
Always CHECK: what should I check?
Re-run the calibration and check the limits.
