Fault finder: Plant shelf light meter

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Sensor not found: what should I check?

Check SDA, SCL and power.

Values far too low: what should I check?

The sensor is facing away from the light.

Display blank: what should I check?

Try address 0x3D instead of 0x3C.

Readings flicker: what should I check?

Indoor LED lamps can flicker, average several readings.

Reads very high in sun: what should I check?

Use the library auto-ranging method.