Fault finder: Variable bench power supply with LM317

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output stuck at 1.25 V: what should I check?

ADJ is not connected to the pot wiper, or the pot is shorted.

Output equals input: what should I check?

The output cannot be adjusted if ADJ is floating. Check the ADJ wire.

Regulator gets very hot: what should I check?

The voltage difference is large. Lower the input or add a bigger heatsink and keep the current low.

Output oscillates: what should I check?

Add the 10 µF output capacitor close to the regulator.