Fault finder: Pocket UV index meter
11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Always zero: what should I check?
Check SDA and SCL, and that the sensor faces the sky.
OLED blank: what should I check?
Try address 0x3D instead of 0x3C.
Readings jump around: what should I check?
Average several readings.
Sensor not found: what should I check?
Some boards use two I2C addresses, 0x38 and 0x39.
Low outdoors: what should I check?
Glass or a plastic cover is blocking the UV.
