Fault finder: Uno DPDT relay motor reverser

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always runs one way: what should I check?

Check the commons go to the motor and that NC and NO are wired as in the table.

Relay does not click: what should I check?

Check the transistor pins and the coil diode direction.

Motor does not start: what should I check?

Check the battery, the TIP120 pins and the common ground.

Uno resets: what should I check?

Run the motor from the battery, not the Uno, and keep the grounds joined.

Motor is noisy: what should I check?

Fit the 100 nanofarad capacitor across its terminals.