Fault finder: Ultrasonic tape measure

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always out of range: what should I check?

Check Trig and Echo are not swapped and the sensor has 5 V.

Reading jumps around: what should I check?

Hold the sensor steady and aim at a flat, hard surface.

Screen blank: what should I check?

Try address 0x3F, or turn the contrast screw on the back.

All readings a few percent off: what should I check?

Set AIR_TEMP_C to the real air temperature.

Minimum distance wrong: what should I check?

The sensor cannot measure under about 2 cm.