Fault finder: Ultrasonic cleaner timer

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Relay is on at power-up: what should I check?

Your module is active-high; change RELAY_ON.

Display shows nothing: what should I check?

Check CLK and DIO are not swapped.

Knob counts the wrong way: what should I check?

Swap the A and B pins.