Fault finder: Design a serial protocol with checksums

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing received: what should I check?

Cross TX to RX and join the grounds.

Every packet bad: what should I check?

Check both boards use the same CRC polynomial and baud rate.

Garbage on the monitor: what should I check?

Match the serial monitor to 115200.

Stalls after noise: what should I check?

Make sure the state machine returns to WAIT_START.