Fault finder: Pocket USB-serial debug tool

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing appears: what should I check?

Swap TX and RX.

Garbage: what should I check?

Match the baud rate.

Port not found: what should I check?

Install the FTDI driver or try another cable.

Board resets: what should I check?

Remove the VCC lead and power the board separately.