Fault finder: Three-step touch lamp

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Lamp never changes: what should I check?

Check the I/O wire on D2 and the module power.

Steps twice per touch: what should I check?

Increase the 300 ms delay.

Lamp flickers: what should I check?

Check the LED wiring and ground.

Starts bright every time: what should I check?

The memory holds an old value, touch through the cycle once.

Pad too sensitive: what should I check?

Move the wires away from the pad.