Fault finder: Road work warning flasher

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Both LEDs on or off: what should I check?

Check the capacitor polarity and the base resistors.

Does not start: what should I check?

Swap a transistor and check the pinout (flat face, C B E varies, check the datasheet).

Dim: what should I check?

Reduce the resistor value a little.

Rate wrong: what should I check?

Check the resistor and capacitor values.