Fault finder: Engine hour meter for pumps and tractors

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts while the engine is off: what should I check?

The sensor is too sensitive or on a shared bench. Lower the trimmer.

Does not count: what should I check?

The engine does not shake the sensor enough. Mount it on a rigid part nearer the engine.

Total resets to zero: what should I check?

EEPROM write failed or was never saved. Run for at least 10 minutes.

Nano resets when starting the engine: what should I check?

Add a 470 µF capacitor at the buck input.