Fault finder: Capacitive touch slider

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Position jumps: what should I check?

Pads are different sizes or wires are too long.

Does not respond: what should I check?

Check I2C address 0x5A and wiring.

Always on: what should I check?

Do not touch during start-up so the baseline is correct.