Fault finder: Touch-contact hit lights

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Scores with no touch: what should I check?

Keep the pad wires apart and check for loose strands.

No score on touch: what should I check?

Press the foil flat and check the tip lead goes to GND.

Both score together: what should I check?

The two pads are touching each other.

No beep: what should I check?

Check the buzzer is the active type and the plus wire is on D8.

Serial shows nothing: what should I check?

Set 9600 baud in the monitor.