Fault finder: Three-step torch with a push button

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check the LED direction, the long leg goes to the resistor side.

Presses skip a mode: what should I check?

Increase the 30 ms debounce, or check for a loose button leg.

Brightness looks the same at medium and high: what should I check?

Raise the medium value from 90 to 120.

SOS looks wrong: what should I check?

Check the SOS table has the full eighteen numbers.

Nano resets when you press: what should I check?

Re-seat the jumper wires, there may be a loose connection.