Projects / Brushing timer / Fault finder

Fault finder: Brushing timer

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always Brushing: what should I check?

Raise MOVE_LEVEL or check the module is held still.

Never Brushing: what should I check?

Lower MOVE_LEVEL, or check the I2C wires and the 0x68 address.

Display blank: what should I check?

Check the OLED address 0x3C and wires.

Sensor not found: what should I check?

Make sure AD0 is low and the module is powered.

Beeps too quiet: what should I check?

Use a passive buzzer on D8 and keep it near.