Fault finder: Temperature sensor comparison lab
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Both read wrong: what should I check?
Check that the flat sides face the same way.
Sensors very hot: what should I check?
A leg is wired to 5V and GND the wrong way round, unplug at once.
Readings jump: what should I check?
Increase the number of samples.
LM35 reads high: what should I check?
Warmth from the board or your hand.
Display blank: what should I check?
Try address 0x3D instead of 0x3C.
