Fault finder: Thermometer bar of lights

8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LEDs light: what should I check?

Check pin 3 and pin 9 are on 5V and the LED direction.

Only one LED lights: what should I check?

Pin 9 left open means dot mode, tie it to 5V.

Bar full all the time: what should I check?

Check the 10 kilohm and 10 microfarad filter parts.

Temperature reads odd: what should I check?

Check the TMP36 pin order, flat face toward you.

LEDs dim: what should I check?

Check the 2.2 kilohm reference resistor.