Fault finder: Kitchen countdown timer

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display blank: what should I check?

Check CLK and DIO are not swapped and the library is installed.

Timer runs fast or slow: what should I check?

Check that no long delay() calls were added to the loop.

Buttons add more than one step: what should I check?

Increase the 25 ms debounce delay.

Buzzer silent: what should I check?

Use a passive buzzer with tone(), and check its polarity.

Colon missing: what should I check?

Use showNumberDecEx with the 0x40 flag as shown.