Fault finder: Digital spirit level

12 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No sensor message: what should I check?

Check VCC, GND, SDA and SCL, and the 0x68 address.

OLED blank: what should I check?

Check 0x3C, or change to 0x3D for some screens.

Angles drift: what should I check?

The board is moving, or the sensor is warming up.

Wrong axis: what should I check?

The module is mounted rotated, swap the formula or the mounting.

No beep: what should I check?

Check the buzzer is passive and on D3.