Fault finder: Tic-tac-toe against the Arduino
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Wrong LED lights: what should I check?
Check the bit order and the chain order.
Dim LEDs: what should I check?
Check resistor values and the common leg.
Ghost presses: what should I check?
Check the button ground wires.
Slow reply: what should I check?
Shorten the search with a first-move shortcut.
