Fault finder: Three-lane rhythm tapper

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Notes never appear: what should I check?

Check the sketch uploaded and the OLED shows the boxes.

A lane never scores: what should I check?

Check the button goes to its pin and to GND.

LED stays dark: what should I check?

Check its direction and the 220 ohm resistor.

Too hard or too easy: what should I check?

Change the starting speedPx or the zone height.