Fault finder: NTC thermistor thermometer

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads very high or very low: what should I check?

The thermistor and resistor are swapped, check the order.

Reading drifts: what should I check?

The probe is warming itself or is near a heat source.

Large error away from 25 C: what should I check?

The beta model is limited, use Steinhart-Hart.

Display blank: what should I check?

Try address 0x3D, and check the display voltage.

Noisy values: what should I check?

Keep the thermistor leads short and away from motors.