Fault finder: Heat index and comfort display
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Readings are NaN: what should I check?
Check DATA pin and the pull-up, and that the library is installed.
Display shows boxes: what should I check?
Adjust the LCD contrast trimmer or check the address 0x27 or 0x3F.
Temperature reads high: what should I check?
The sensor is in sun or near the board. Move it away.
Colours wrong: what should I check?
A common anode LED needs inverted values.
