Projects / Light theremin / Fault finder

Fault finder: Light theremin

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No sound: what should I check?

A passive buzzer needs tone(). Check D8 and the wiring.

Always the same note: what should I check?

Calibration failed. Reset and wave over both sensors.

Notes jitter: what should I check?

Increase the smoothing weight or shade the sensors from other lights.

Pitch backwards: what should I check?

Swap the min and max in the map or swap the LDR and resistor positions.