Fault finder: Mini scope display on TFT

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Trace jumps: what should I check?

Raise or lower the trigger level.

Trace looks jagged: what should I check?

Use a slower timebase or draw fewer points.

Clipping at the top: what should I check?

The signal exceeds 3.3 V; use a divider.

Blank screen: what should I check?

Check the CS, DC and RST pins.