Fault finder: Terrarium warm spot watch

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Probe error message: what should I check?

Check the 4.7 kilohm pull-up and the data wire on D2.

AHT20 not found: what should I check?

Check SDA, SCL and power.

Readings disagree: what should I check?

Check each against a separate thermometer.

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

LED never flashes: what should I check?

Lower WARM_MAX to test it.