Fault finder: Terrarium mist reminder

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Stops at sensor begin: what should I check?

Check the address 0x44 or 0x45 and the I2C wires.

Humidity reads 100: what should I check?

Condensation on the sensor, dry it and move it up.

No beep: what should I check?

Check the buzzer is passive and on GPIO25.

Display blank: what should I check?

Check the OLED address 0x3C.

Beeps too often: what should I check?

Use the mute button or lengthen the reminder time.