Fault finder: Room temperature and humidity logger with SD card

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No file on the card: what should I check?

Wrong CS pin, a non-FAT32 card or a module without 5 V level shifting.

Time is wrong: what should I check?

The RTC lost power and was set at compile time. Re-upload to reset it.

Readings stuck: what should I check?

The sensor is not found. Check the I2C wiring.

LED never blinks: what should I check?

The SD card failed to open. Reseat the card.