Fault finder: Temperature-controlled 12 V fan

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Fan always on full: what should I check?

The MOSFET is wired as drain and source swapped, or the gate pull-down is missing.

Fan never starts: what should I check?

Use a logic-level MOSFET (IRLZ44N, not IRFZ44N), and check the fan's black wire goes to the drain.

Fan clicks at low speed: what should I check?

Raise the 100 minimum in map() to 130.

The Uno resets: what should I check?

The flyback diode is missing or reversed.