Fault finder: Temperature threshold alarm

12 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads −127: what should I check?

Missing 4.7 kΩ pull-up or yellow wire not on D4.

Reads 85 every time: what should I check?

Power-on value: the conversion did not finish; check supply wiring.

Limit jumps around: what should I check?

Pot wiper loose; average a few readings.