Fault finder: Tank fill control with float switches

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Pump never starts: what should I check?

Check the float contact direction and the relay polarity.

Chatters: what should I check?

Raise the low float further below the high one.

Relay clicks but the pump is dead: what should I check?

Check the pump fuse and wiring.

Alarm on start: what should I check?

Reset the board after fixing the fault.