Fault finder: Take-a-number queue display

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display stays dark: what should I check?

Check the TM1637 power, CLK and DIO wires.

Wrong digits: what should I check?

Check CLK is D2 and DIO is D3.

Call does nothing: what should I check?

Take a ticket first.

Library not found: what should I check?

Install TM1637Display.

Buttons seem to repeat: what should I check?

Release them cleanly.