Fault finder: Switch types gallery
9 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No LED lights: what should I check?
Check the LED direction and the supply.
Latching button has no effect: what should I check?
Check which pins are the contacts.
Both toggle LEDs light: what should I check?
The common terminal is on the wrong pin.
LED always on: what should I check?
The switch contacts are bridged on the breadboard.
LED dim: what should I check?
Check the 330 ohm resistor value.
