Fault finder: Vibration timer for a machine

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never reaches Running: what should I check?

Turn the sensitivity pot up or stick the sensor flat on a panel that shakes.

Always Running: what should I check?

Sensitivity is too high or the module output is inverted.

Beeps in the middle of a cycle: what should I check?

Increase QUIET_MS.

Pulses stay at zero: what should I check?

Check the DO wire on D2.

Display blank: what should I check?

Try address 0x3D instead of 0x3C.