Fault finder: Mini sumo robot
10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Drives off the ring: what should I check?
Edge threshold wrong or sensors too high.
Does not see the opponent: what should I check?
Lower SEE or aim the sensors forward.
Spins in one place: what should I check?
A motor wire is reversed.
