Fault finder: Stopwatch with lap times
7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
LCD blank: what should I check?
Try address 0x3F, or turn the contrast screw.
Buttons double count: what should I check?
Increase the debounce delay, or check for loose wires.
Time runs off compared with a phone: what should I check?
Check for long delay() calls in changes you made.
Garbage characters: what should I check?
The row text was too long, check the padding spaces.
Laps do not register: what should I check?
Lap only works while running.
