Fault finder: Bare-metal blink on STM32

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Programmer cannot connect: what should I check?

Check the four wires and the BOOT jumpers.

Wrong chip ID: what should I check?

Choose the clone-chip option for upload.

No blink: what should I check?

Check the clock enable lines before the pin set-up.