Projects / Time-lapse slider / Fault finder

Fault finder: Time-lapse slider

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Motor only buzzes: what should I check?

Check coil pairs; swap one pair's wires.

Wrong distance: what should I check?

Recalculate STEPS_PER_MM.

Skips steps: what should I check?

Lower the speed or raise the current slightly within the motor's rating.

Driver gets hot: what should I check?

Lower the current setting and add a heatsink.