Fault finder: Stepper motor first steps

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Only vibrates: what should I check?

Check the pin order in the PINS array and the plug.

Does not move: what should I check?

Check the separate 5 V supply and the common ground.

Gets hot: what should I check?

Release the coils after moving; it already does in this sketch.

Skips steps: what should I check?

Increase stepDelayMs and check the supply.